ten. If the nonces of most chips in all the miner or solitary board are returned to 0, it will likely be a chip welding trouble. Reinstall it and it'll be OK.

two. For the first time use the 19 series test fixture SD card flash plan to update the FPGA control board of the tester, copy it to the SD card right after decompression, and insert the SD card in the fixture card slot: Power on for about one minute, and anticipate the crimson and inexperienced indicators about the Handle board to flash three moments in succession, then the update is entire (if it is not updated, it may well bring about a hard and fast chip to generally be reported as faulty in the course of the examination).

Step 3: Simply click the “system” button. Following completion, simply click “validate”. It's going to prompt that the verification is accomplished to confirm the burning is productive.

Get the most effective mining efficiency out of the Antminer T19 by utilizing the proper software package. Be a part of minerstat and locate the most fitted application on your set up.

a-3) Measure the resistance of R8 or R9 using a multimeter to examine whether it is within just 10 ohms as well as the examining will not likely jump randomly. If not, remember to switch these two resistors

Should the temperature exceeds this temperature, the miner will alarm and cannot function Ordinarily. Normally, you could check if the h2o outlet temperature exceeds sixty five degrees, and thermal conductive gel may lead to temperature abnormalities.

The subsequent fault illustrations are from Antminer 19 collection mining equipment, other Antminer designs are for reference only.

The repaired hash board could be judged as a good products with greater than two passes when analyzed Go Here With all the hash board tester.

Evaluate whether or not There exists output on the 2nd pin of U6 and also the voltage is about 3.3V; if Certainly, make sure you keep on to troubleshoot the trouble; if there is no 3.

If one particular chip is discovered, Examine the next chips making use of an analogous system and quick-circuiting the 1V8 exam level and the RO exam level concerning the 38th and 39th chips to locate the problematic chip.

① To begin with, visually inspect the hash board to view if there is any deformation or burning in the PCB. If there is any phenomenon, it have to be handled to start with.

Home windows mining Our mining checking and management program for Windows GPU rigs is the perfect Alternative for many who choose to mine on their Windows equipment.

Lately, quite a few businesses boasting to get mining companies imitate us and say that they are connected with us, or that they're our department providers, that has triggered prospects to be deceived.

Home windows mining Our mining checking and administration software for Windows GPU rigs is the right Remedy for many who prefer to mine on their Home windows equipment.